Foam Grip *Installing Foam Grip: 1. You Must take the handle out of the bag. If not it may damage the rods of the sliding handles. 2. Remove the 4 screws on the rings at the top of the bag. 3. Squeeze the triggers together as you pull the handle out of the bags. NOTE: for the ALUMINUM HANDLE there is a screw under foam. Remove the screw so that the rod will release from the coupler. NOTE: for the STAINLESS STEEL HANDLE there is a pin under the foam. Take a small nail to drive the pin out to allow the rod to release from the coupler. 5. Pull the old foam off and install the new foam. You may need to lubricate the coupler so that the foam grip will slide on easily for you. 6. Reinstall the rod/screw or rod/pin to the coupler. 7. Squeeze teh triggers together and reinstall the sliding handle back into the bag. 8. Put the 4 screws back into the rings.